University of Queensland physicists used a 1950s elevator to send the word ‘Gravity’ through a brick wall without radio or light. The university announced the experiment on November 19.
How an elevator sent 49 bits
The researchers moved the lift between two floors, shifting its roughly 1.8-tonne counterweight between positions representing zero and one. A gravimeter in an adjoining restroom detected the small changes in gravitational pull. At its closest, the counterweight was about 68 centimetres from the sensor. The seven-letter word used 49 bits; with start and end markers, the transmission took about an hour at roughly one bit per minute, XenoSpectrum reported.
A truck-weighing project inspired the idea
Andrew Groszek said the idea grew out of work on a contactless weighbridge, also reported by Bioengineer.org. The weighbridge would use a gravity reading to infer a vehicle’s mass. For the message, the team reversed the logic: it moved a known mass and used the change in pull to encode information.
The wall wasn’t the bottleneck
The signal was a change in the local gravitational field, not a gravitational wave. The wall did not screen out that change. The challenge was moving enough mass quickly enough for the detector to distinguish the two positions. The experiment, reported in Science Advances, worked over less than a metre. The university cited modelled figures of about 15 bits per minute and roughly 500 metres; neither was demonstrated, and the announcement does not establish that both could be reached in the same setup.

